Calendar Control: I can't see the year.

[sloopa]

I can't see the full year in calendar control on device - only first three digits (On desktop everything is fine). Everytime I want to change the year I must scroll.
And because of scrolling the up down button is useless, because I can't see the last but most important digit.

Do you have the same problem or is this only on my ppc?

Does somebody have a solution?

[specci48]

Hi sloopa,

the calendar control works fine fore me on my iPAQ device.
Are you using a large font on your device or have you changed the font size of the calendar control (default = 9) ?


specci48

[sloopa]

Hi Specci,

Try to select the year in the calendar... it won't work.

I post this error again in the german forum...

[specci48]

Hi sloopa,

I attached a screenshot from my device with a selected year.

As you can see, the year looks fine so there is no permanent problem with the calendar control.


specci

[klaus]

Hi sloopa,

Here is a screenshot from my Qtek9090.

As specci's it works OK.

Could you post your source code so we could try yours to compare it.
The source code where I tested mine, you can find it there:
Elektroschaltplan zeichen
Click on the upper left button for a new sketch, and answer yes to the MessageBox, then you arrive where the Calender control is.

Best regards.